Specifications

2-94
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
Universal Router Module
Note If you have not connected a terminal to the CON port on the back card, you will not see the
embedded router’s initial start-up screens (see the “Cisco IOS Software Commands for the
URM” section on page 2-103 for an example startup screen).
Step 5 (Optional) Configure the internal ATM port to support ILMI with the switch software cnfport
command.
Note The port does not support LMI management protocol and should be configured to support either
ILMI or none. If ILMI is not configured on the internal ATM port, the embedded UXM-E does
not discover the assigned IP addresses for the URM card.
Step 6 Activate the internal ATM port with the switch software upport command.
Step 7 Configure ATM connections onto the embedded UXM-E with the switch software addcon command.
For more information on configuring ATM connections, see Chapter 8, “Cisco IGX 8400 Series ATM
Service”
Timesaver If you want the Cisco IOS configuration to load from NVRAM in the future, use the switch software
cnfrtr slot r command at the switch software CLI.
Step 8 Connect a dedicated console to the URM through the serial port (CON) located on the back card (see
Figure 2-43).
Note For additional methods of accessing the URM Cisco IOS CLI, see the section “URM Cisco IOS
CLI Access—Switch Software Release 9.3.x and Earlier Releases” and the “URM Cisco IOS
CLI Access—Switch Software Release 9.4.0 and Later Releases” section on page 2-99.
Step 9 (Optional) Use the Cisco IOS show version command to view information presented in the embedded
router’s initial startup screens.
Example 2-1 Cisco IOS show version Command Entered
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) 3600 Software (URM-IS-M), Version 12.1(5)YA
TAC Support:http://www.cisco.com/cgi-bin/ibld/view.pl?i=support
Copyright (c) 1986-2001 by cisco Systems, Inc.
Compiled Wed 24-Jan-01 12:29 by yiyan
Image text-base:0x60008960, data-base:0x6113E000
ROM:System Bootstrap, Version 12.1(5r)YA, RELEASE SOFTWARE (fc1)
ROM:3600 Software (URM-IS-M), Version 12.1(5)YA
Router uptime is 2 minutes
System returned to ROM by power-on
System image file is "flash:urm-is-mz.121-5.YA"
cisco URM (R527x) processor (revision 01) with 57344K/8192K bytes of memory.
Processor board ID
R527x CPU at 225Mhz, Implementation 40, Rev 10.0
Bridging software.