Specifications
2-76
Cisco IGX 8400 Series Provisioning Guide, Release 9.3.3 and Later Releases
OL-1166-04
Chapter 2 Cisco IGX 8400 Series Cards
High-Speed Data Module
High-Speed Data Module
Table 2-45 shows the front and back cards supported for the high-speed data module (HDM).
The HDM consists of an HDM front card and a synchronous data interface (SDI) back card. There are
three different models of the SDI back card, depending on the desired interface type (see Table 2-45 and
Table 2-47). Depending on the chassis type, the IGX can support up to 29 HDMs for up to
232 full-duplex data connections.
The HDM supports the following features:
• Support for four high-speed synchronous data channels
• Separately-configurable channels, with configurable clocking, data rate, and interface type
• Support for multiple protocols (asynchronous, binary synchronous, and bit synchronous)
• Port speeds from 1.2 kbps up to 1344 kbps
• Configuration and monitoring of control leads
• Support for loopback testing
• Support for Y-cable redundancy
HDM Front Card
The HDM front card faceplate shown in Figure 2-36 has both LEDs and control buttons to assist with
loopback control and signal monitoring tasks. See Table 2-46 for more information about the HDM front
card faceplate LEDs and the “HDM Control Buttons” section on page 2-78 for more information on
HDM front card faceplate control buttons.
Table 2-45 High-Speed Data Module Front and Back Cards
Front Card Back Cards
HDM SDI, EIA/TIA-449 (for X.21 also)
SDI, EIA/TIA-232D (for V.24 also)
SDI, V.35