Specifications

18-9

System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches

Chapter 18 Configuring Online Diagnostics

Configuration Example

POST: PortASIC CAM Subsystem Tests : End, Status Passed

POST: PortASIC Port Loopback Tests : Begin

POST: PortASIC Port Loopback Tests : End, Status Passed

For more examples of other show diagnostic command outputs, see the “Examples” section of the show

diagnostic command in the Cisco IOS Configuration Fundamentals Command Reference, Release

15.2M&T.

Configuration Example

This example shows how to schedule diagnostic testing for a specific day and time and verify the schedule:

Switch(config)# diagnostic schedule test 1 on Dec 4 2013 10:22

Switch(config)# end

Switch# show diagnostic schedule

Current Time = 10:21:24 UTC Thu Dec 4 2013

Diagnostic:

Schedule #1:

To be run on December 4 2013 10:22

Test ID(s) to be executed: 1.

At the scheduled time, the switch runs the test:

Switch# #

Dec 4 10:21:59.492: %DIAG-6-SCHED_RUNNING: : Performing Scheduled Online Diagnostic...

Dec 4 10:21:59.492: %DIAG-6-TEST_RUNNING: : Running TestPortAsicStackPortLoopback{ID=1}

Dec 4 10:22:00.498: %DIAG-6-TEST_OK: : TestPortAsicStackPortLoopback{ID=1} has completed

successfully

Dec 4 10:22:00.498: %DIAG-6-SCHED_COMPLETE: : Scheduled Online Diagnostic is completed

This example shows how to configure a health-monitoring test:

Switch(config)# diagnostic monitor threshold test 1 failure count 50

Switch(config)# diagnostic monitor interval test TestPortAsicRingLoopback