Specifications

18-3
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 18 Configuring Online Diagnostics
Configuring Online Diagnostics
Configuring Online Diagnostics
You must configure the failure threshold and the interval between tests before enabling diagnostic
monitoring.
• Scheduling Online Diagnostics, page 18-3
• Configuring Health-Monitoring Diagnostics, page 18-4
Scheduling Online Diagnostics
You can schedule online diagnostics to run at a designated time of day or on a daily, weekly, or monthly
basis. Use the no form of this command to remove the scheduling. For detailed information about this
command, see the Cisco IOS Configuration Fundamentals Command Reference, Release 15.2M&T.
BEFORE YOU BEGIN
Review the “Information About Online Diagnostics” section on page 18-1 and “Guidelines and
Limitations” section on page 18-2.
DETAILED STEPS
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
diagnostic schedule test {name | test-id |
test-id-range | all | basic | non-disruptive}
{daily hh:mm | on mm dd yyyy hh:mm |
weekly day-of-week hh:mm}
Schedule on-demand diagnostic tests for a specific day
and time.
When specifying the tests to be scheduled, use these
options:
• name—Name of the test that appears in the show
diagnostic content command output. See Table 18-1.
• test-id—ID number of the test that appears in the
show diagnostic content command output. See
Table 18-1.
• test-id-range—A range of test ID numbers separated
by a hyphen or commas.
• all—All of the diagnostic tests.
• basic—Basic on-demand diagnostic tests.
• non-disruptive—Nondisruptive health-monitoring
tests.
You can schedule the tests for these time periods:
• Daily—Use the daily hh:mm parameter.
• Specific day and time—Use the on mm dd yyyy
hh:mm parameter.
• Weekly—Use the weekly day-of-week hh:mm
parameter.