Specifications

17-30
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 17 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Y.1731 Fault Management
Step 6
ethernet cfm domain domain-name level
level-id
Define a CFM domain, set the domain level, and
enter ethernet-cfm configuration mode for the
domain. The maintenance level number range is 0 to
7.
Step 7
service {ma-name | ma-number | vpn-id vpn}
{vlan vlan-id [direction down] | port}
Define a customer service maintenance association
name or number to be associated with the domain, or
a VLAN ID or VPN-ID, and enter
ethernet-cfm-service configuration mode.
• ma-name—a string of no more than 100
characters that identifies the MAID.
• ma-number—a value from 0 to 65535.
• vpn-id—enter a VPN ID as the ma-name.
• vlan vlan-id—VLAN range is from 1 to 4094.
You cannot use the same VLAN ID for more
than one domain at the same level.
• (Optional) direction down—specify the service
direction as down.
• port—Configure port MEP, a down MEP that is
untagged and not associated with a VLAN.
Step 8
lck level level-id (Optional) Configure the maintenance level for
sending ETH-LCK frames sent by the MEP. The
range is 0 to 7.
Step 9
lck period value (Optional) Configure the MEP ETH-LCK frame
transmission period interval. Allowable values are 1
second or 60 seconds.
Step 10
lck expiry-threshold value (Optional) Set the expiring threshold for the MA.
The range is 2 to 255. The default is 3.5.
Step 11
exit Return to ethernet-cfm configuration mode.
Step 12
exit Return to global configuration mode.
Step 13
interface interface-id Specify an interface ID, and enter interface
configuration mode.
Step 14
[no] ethernet cfm lck link-status Enable or disable sending ETH-LCK frames from
the SMEP on the interface.
Step 15
ethernet cfm lck link-status period value Configure the ETH-LCK transmission period
generated by the SMEP on the interface. Allowable
values are 1 second or 60 seconds.
Step 16
ethernet cfm lck link-status level level-id Configure the maintenance level for sending
ETH-LCK frames sent by the SMEP on the
interface. The range is 0 to 7.
Step 17
end Return to privileged EXEC mode.
Command Purpose