Specifications

17-18
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 17 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
DETAILED STEPS
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
ethernet cfm alarm notification {all |
error-xcon | mac-remote-error-xcon | none |
remote-error-xcon | xcon}
Globally enable Ethernet CFM fault alarm
notification for the specified defects:
• all—report all defects.
• error-xcon—Report only error and connection
defects.
• mac-remote-error-xcon—Report only
MAC-address, remote, error, and connection
defects.
• none—Report no defects.
• remote-error-xcon—Report only remote, error,
and connection defects.
• xcon—Report only connection defects.
Step 3
ethernet cfm alarm delay value (Optional) Set a delay period before a CFM fault
alarm is sent. The range is 2500 to 10000
milliseconds (ms). The default is 2500 ms.
Step 4
ethernet cfm alarm reset value (Optional) Specify the time period before the CFM
fault alarm is reset. The range is 2500 to 10000
milliseconds (ms). The default is 10000 ms.
Step 5
ethernet cfm logging alarm ieee Configure the switch to generate system logging
messages for the alarms.
Step 6
interface interface-id (Optional) Specify an interface to configure, and
enter interface configuration mode.
Step 7
ethernet cfm mep domain domain-name mpid
identifier vlan vlan-id
Configure maintenance end points for the domain,
and enter ethernet cfm interface mep mode.
• domain domain-name—Specify the name of the
created domain.
• mpid identifier—Enter a maintenance end point
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to
8191.
• vlan vlan-id—Enter the service provider VLAN
ID or IDs as a VLAN-ID (1 to 4094), a range of
VLAN-IDs separated by a hyphen, or a series of
VLAN IDs separated by comma.
Step 8
ethernet cfm alarm notification {all |
error-xcon | mac-remote-error-xcon | none |
remote-error-xcon | xcon}
(Optional) Enable Ethernet CFM fault alarm
notification for the specified defects on the interface.
Note The Ethernet CFM interface MEP alarm
configuration takes precedence over the
global configuration.