Specifications

17-9
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 17 Configuring Ethernet OAM, CFM, and E-LMI
Configuring Ethernet CFM
Step 3
ethernet cfm traceroute cache [size entries |
hold-time minutes]
(Optional) Configure the CFM traceroute cache. You
can set a maximum cache size or hold time.
• (Optional) For size, enter the cache size in
number of entry lines. The range is from 1 to
4095; the default is 100 lines.
• (Optional) For hold-time, enter the maximum
cache hold time in minutes. The range is from 1
to 65535; the default is 100 minutes.
Step 4
ethernet cfm mip auto-create level level-id
vlan vlan-id
(Optional) Configure the switch to automatically
create MIPs for VLAN IDS that are not associated
with specific maintenance associations at the
specified level. The level range is 0 to 7.
Note Configure MIP auto-creation only for
VLANs that MIPs should monitor.
Configuring for all VLANs can be CPU and
memory-intensive.
Step 5
ethernet cfm mip filter (Optional) Enable MIP filtering, which means that
all CFM frames at a lower level are dropped. The
default is disabled.
Step 6
ethernet cfm domain domain-name level
level-id
Define a CFM domain, set the domain level, and
enter ethernet-cfm configuration mode for the
domain. The maintenance level number range is 0 to
7.
Step 7
id {mac-address domain_number | dns name |
null}
(Optional) Assign a maintenance domain identifier.
• mac-address domain_number—Enter the MAC
address and a domain number. The number can
be from 0 to 65535.
• dns name—Enter a DNS name string. The name
can be a maximum of 43 characters.
• null—Assign no domain name.
Command Purpose