Specifications

13-6
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 13 Configuring System Message Logging
Configuring System Message Logging
To disable logging to the console, use the no logging console global configuration command. To disable
logging to a file, use the no logging file [severity-level-number | type] global configuration command.
EXAMPLE
The following example shows how to enable standard system logging to the local syslog buffer:
Switch(config)# logging buffered
Synchronizing Log Messages
You can synchronize unsolicited messages and debug privileged EXEC command output with solicited
device output and prompts for a specific console port line or virtual terminal line. You can identify the
types of messages to be output asynchronously based on the level of severity. You can also configure the
maximum number of buffers for storing asynchronous messages for the terminal after which messages
are dropped.
When synchronous logging of unsolicited messages and debug command output is enabled, unsolicited
device output appears on the console or printed after solicited device output appears or is printed.
Unsolicited messages and debug command output appears on the console after the prompt for user input
is returned. Therefore, unsolicited messages and debug command output are not interspersed with
solicited device output and prompts. After the unsolicited messages appear, the console again displays
the user prompt.
Step 4
logging file flash:filename
[max-file-size [min-file-size]]
[severity-level-number | type]
Store log messages in a file in flash memory.
• For filename, enter the log message filename.
• (Optional) For max-file-size, specify the maximum logging
file size. The range is 4096 to 2147483647. The default is
4096 bytes.
• (Optional) For min-file-size, specify the minimum logging
file size. The range is 1024 to 2147483647. The default is
2048 bytes.
• (Optional) For severity-level-number | type, specify either
the logging severity level or the logging type. The severity
range is 0 to 7. For a list of logging type keywords, see
Table 13-2 on page 13-10. By default, the log file receives
debugging messages and numerically lower levels.
Step 5
end Return to privileged EXEC mode.
Step 6
terminal monitor Log messages to a nonconsole terminal during the current
session.
Terminal parameter-setting commands are set locally and do not
remain in effect after the session has ended. You must perform
this step for each session to see the debugging messages.
Step 7
show running-config Verify your entries.
Step 8
copy running-config
startup-config
(Optional) Save your entries in the configuration file.
Command Purpose