Specifications

13-3
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 13 Configuring System Message Logging
Prerequisites
*Mar 1 18:46:11: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
18:47:02: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
*Mar 1 18:48:50.483 UTC: %SYS-5-CONFIG_I: Configured from console by vty2 (10.34.195.36)
Prerequisites
Review the “Information About System Message Logging” section on page 13-1.
Guidelines and Limitations
Caution Logging messages to the console at a high rate can cause high CPU utilization and adversely affect how
the switch operates.
Default Settings
Configuring System Message Logging
• Disabling Message Logging, page 13-4 (optional)
• Setting the Message Display Destination Device, page 13-5 (optional)
• Synchronizing Log Messages, page 13-6 (optional)
• Enabling and Disabling Time Stamps on Log Messages, page 13-8 (optional)
• Enabling and Disabling Sequence Numbers in Log Messages, page 13-9 (optional)
Feature Default Setting
System message logging to the console Enabled.
Console severity Debugging (and numerically lower levels; see
Table 13-2 on page 13-10).
Logging file configuration No filename specified.
Logging buffer size 4096 bytes.
Logging history size 1 message.
Time stamps Disabled.
Synchronous logging Disabled.
Logging server Disabled.
Syslog server IP address None configured.
Server facility Local7 (see Table 13-3 on page 13-15).
Server severity Informational (and numerically lower levels; see
Table 13-2 on page 13-10).