Specifications

12-4
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 12 Configuring RMON
Configuring RMON
DETAILED STEPS
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
rmon alarm number variable interval {absolute |
delta} rising-threshold value [event-number]
falling-threshold value [event-number]
[owner string]
Set an alarm on a MIB object.
• For number, specify the alarm number.
The range is 1 to 65535.
• For variable, specify the MIB object to
monitor.
• For interval, specify the time in seconds
the alarm monitors the MIB variable. The
range is 1 to 4294967295 seconds.
• Specify the absolute keyword to test
each MIB variable directly. Specify the
delta keyword to test the change between
samples of a MIB variable.
• For value, specify a number at which the
alarm is triggered and one for when the
alarm is reset. The range for the rising
threshold and falling threshold values is
-2147483648 to 2147483647.
• (Optional) For event-number, specify the
event number to trigger when the rising
or falling threshold exceeds its limit.
• (Optional) For owner string, specify the
owner of the alarm.
Step 3
rmon event number [description string] [log] [owner
string] [trap community]
Add an event in the RMON event table that is
associated with an RMON event number.
• For number, assign an event number. The
range is 1 to 65535.
• (Optional) For description string,
specify a description of the event.
• (Optional) Use the log keyword to
generate an RMON log entry when the
event is triggered.
• (Optional) For owner string, specify the
owner of this event.
• (Optional) For trap community, enter the
SNMP community string used for this
trap.
Step 4
end Return to privileged EXEC mode.
Step 5
show running-config Verify your entries.
Step 6
copy running-config startup-config (Optional) Save your entries in the
configuration file.