Specifications

11-22
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
OL-29255-03
Chapter 11 Configuring SPAN and RSPAN
Configuring SPAN and RSPAN
Creating an RSPAN Destination Session and Configuring Ingress Traffic
Follow this procedure to create an RSPAN destination session, to specify the source RSPAN VLAN and
the destination port, and to enable ingress traffic on the destination port for a network security device
(such as a Cisco IDS Sensor Appliance).
BEFORE YOU BEGIN
Configure the RSPAN VLAN as described in the “Creating an RSPAN Destination Session” section on
page 11-20.
DETAILED STEPS
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no monitor session
{session_number | all | local |
remote}
Remove any existing SPAN configuration for the session.
Step 3
monitor session session_number
source remote vlan vlan-id
Specify the RSPAN session and the source RSPAN VLAN.
For session_number, the range is 1 to 66.
For vlan-id, specify the source RSPAN VLAN to monitor.