Specifications

8-8
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 8 Configuring LLDP and LLDP-MED
Configuring LLDP and LLDP-MED
Disabling a TLV
BEFORE YOU BEGIN
Review the “Information About LLDP and LLDP-MED” section on page 8-1.
DETAILED STEPS
EXAMPLE
This example shows how to disable a TLV:
Switch# configure terminal
Switch(config)# interface GigabitEthernet1/0/1
Switch(config-if)# no lldp med-tlv-select inventory-management
Switch(config-if)# end
Enabling a TLV
BEFORE YOU BEGIN
Review the “Information About LLDP and LLDP-MED” section on page 8-1.
DETAILED STEPS
network-policy LLDP-MED network policy TLV
power-management LLDP-MED power management TLV
Table 8-1 LLDP-MED TLVs (continued)
LLDP-MED TLV Description
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Specify the interface on which you are configuring a
LLDP-MED TLV, and enter interface configuration mode.
Step 3
no lldp med-tlv-select tlv Specify the TLV to disable.
Step 4
end Return to privileged EXEC mode.
Step 5
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
interface interface-id Specify the interface on which you are configuring an
LLDP-MED TLV, and enter interface configuration mode.
Step 3
lldp med-tlv-select tlv Specify the TLV to enable.