Specifications

7-5
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 7 Configuring Smartports Macros
Configuring Smartports Macros
Applying Smartports Macros
BEFORE YOU BEGIN
Review the “Guidelines and Limitations” section on page 7-1.
DETAILED STEPS
Command Purpose
Step 1
show parser macro Display the Cisco-default Smartports macros embedded in the
switch software.
Step 2
show parser macro name
macro-name
Display the specific macro that you want to apply.
Step 3
configure terminal Enter global configuration mode.
Step 4
macro global {apply | trace}
macro-name [parameter {value}]
[parameter {value}] [parameter
{value}]
Apply each individual command defined in the macro to the
switch by entering macro global apply macro-name. Specify
macro global trace macro-name to apply and to debug a macro
to find any syntax or configuration errors.
Append the macro with the required values by using the
parameter value keywords. Keywords that begin with $ require
a unique parameter value.
You can use the macro global apply macro-name ? command
to display a list of any required values for the macro. If you
apply a macro without entering the keyword values, the
commands are invalid and are not applied.
(Optional) Specify unique parameter values that are specific to
the switch. You can enter up to three keyword-value pairs.
Parameter keyword matching is case sensitive. The
corresponding value replaces all matching occurrences of the
keyword.
Step 5
interface interface-id (Optional) Enter interface configuration mode, and specify the
interface on which to apply the macro.
Step 6
default interface interface-id (Optional) Clear all configuration from the specified interface.