Specifications

6-6
System Management Software Configuration Guide for Cisco IE 2000U and Connected Grid Switches
Chapter 6 Configuring SDM Templates
Verifying Configuration
To return to the default template, use the no sdm prefer global configuration command.
This example shows how to configure a switch with the layer-2 template:
Switch(config)# sdm prefer layer-2
Switch(config)# end
Switch# reload
Proceed with reload? [confirm]
Verifying Configuration
Use the show sdm prefer privileged EXEC command with no parameters to display the active template.
Use the show sdm prefer [default | dual-ipv4-and-ipv6 {default | routing | vlan} | layer-2] privileged
EXEC command to display the resource numbers supported by the specified template.
This is an example of output from the show sdm prefer command, displaying the template in use:
Switch# show sdm prefer
The current template is "default" template.
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 5K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 9K
number of directly-connected IPv4 hosts: 5K
number of indirect IPv4 routes: 4K
number of IPv4 policy based routing aces: 0.5K
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K
This is an example of output from the show sdm prefer layer-2 command:
Switch# show sdm prefer layer-2
"layer-2" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 8K
number of IPv4 IGMP groups: 1K
number of IPv4 multicast routes: 0
number of IPv4 unicast routes: 0
number of IPv4 policy based routing aces: 0
number of IPv4/MAC qos aces: 0.5K
number of IPv4/MAC security aces: 1K
This is an example of output from the show sdm prefer dual-ipv4-and-ipv6 routing command:
Switch# show sdm prefer dual-ipv4-and-ipv6 routing
"desktop IPv4 and IPv6 routing" template:
The selected template optimizes the resources in
the switch to support this level of features for
8 routed interfaces and 1024 VLANs.
number of unicast mac addresses: 1.5K
number of IPv4 IGMP groups + multicast routes: 1K
number of IPv4 unicast routes: 2.75K
number of directly-connected IPv4 hosts: 1.5K
number of indirect IPv4 routes: 1.25K
number of IPv6 multicast groups: 1.125k