Datasheet

9E0 - 100
Leading the way in IT testing and certification tools, www.testking.com
- 23 -
C. clear trunk 9/2 1-1024
D. clear trunk 9/1 1-1024
E. set trunk 9/1 199
F. clear trunk 9/1 199
Answer: D, E
Reference:
Cisco Catalyst 5000 Series Switches - Switch and ROM Monitor
Commands¿Release 6.2
Note: In the new course we think the answer would be this
Router(config)#interface vlan <vlan_number> - creates or access the vlan interface specified
Router(config)# interface vlan 401
Router(config-if)mlp ip ids <acl_name> - applies an IP acl to the vlan interface
The mpl ip ids command is used to apply an extended ip access list to the vlan interface
-Cisco Secure Intrusion Detection System 4 chap 5 page 48
QUESTION NO: 40
How many interactive login sessions to the IDSM are allowed?
A. 1
B. 2
C. 3
D. 4
Answer: A
Note: In the IDSM chapter I did not come across anything that stated this. In fact there is not
much listed in the IDSM chapter. The main thrust was that it uses the same code as the ver4
sensors so it works the same except for some alterations.. Cisco Secure Intrusion Detection
System 4 chap 4
QUESTION NO: 41
The Cisco IDS Sensor service pack file IDSk9-sp-3.1-2-S23.bin exists on the Sensor.
Which command installs the service pack on the Sensor?
A. IDSk9-sp-3.1-2-S23 –install
B. IDSk9-sp-3.1-2-S23.bin –install
C. IDSk9-sp-3.1-2-S23.bin –i
D. IDSk9-sp-3.1-2-S23.bin –l
E. IDSk9-sp-3.1-2-S23-bin –apply
F. IDSk9-sp-3.1-2-S23 –apply
Answer: E