Datasheet

9E0 - 100
Leading the way in IT testing and certification tools, www.testking.com
- 13 -
QUESTION NO: 20
Debugging a PIX is what you want to do to resolve a problem.
What command would you use to display the current state of tracing?
A. show debug
B. debug all
C. all on debug
D. debug crypto
Answer: A
Explanation:
The debug command lets you view debug information. The show debug command displays
the current state of tracing. You can debug the contents of network layer protocol packets with
the debug packet command
Reference: Cisco PIX Firewall Command Reference, Version 6.3
. Note: in Appendix B of the Cisco Secure Intrusion Detection System 4 Debugging is not
talked about.
QUESTION NO: 21
RIP uses a port to establish communications. If you were to block it with your Firewall,
what port would you be concerned about?
A. Port 345
B. Port 345
C. Port 520
D. Port 354
Answer: C
Explanation:
Port 520 is the Routing Information Protocol port.
Reference:
Cisco PIX Firewall Software - Introduction
Note: Rip is not talked about in this manner in the course manual 4
QUESTION NO: 22
Exhibit:
If you were looking at the back of your PIX firewall and saw the following plate, what
model of PIX would you be working on?
A. 501
B. 506
C. 515