User guide

33
Release Notes for Cisco IOS Release 12.4T
OL-8012-09 Rev. B0
Platform-Specific Information
Multipartition Flash Defaults
When you use a multipartition Flash card, the various flash partitions are referred to as “flash:1:”,
“flash:2:”, and so on. If you specify only “flash” in a multipartition flash, the parser assumes “flash:1:”.
For example, if you enter the show flash all command, the parser defaults to “show flash:1: all” and only
the flash information for the first partition displays. To display information for all flash partitions, enter
the show flash ? command, which will list all of the valid partitions. Then enter the show flash:xx: all
command on each valid partition.