Installation guide

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
How to Configure EtherSwitch HWICs
6
Cisco IOS Release 12.3(8)T4
OL-6454-01
DETAILED STEPS
Verifying the VLAN Configuration
You can verify the VLAN configuration in VLAN database mode.
Use the show command in VLAN database mode to verify the VLAN configuration, as shown below:
Router(vlan)#show
VLAN ISL Id: 1
Name: default
Media Type: Ethernet
VLAN 802.10 Id: 100001
State: Operational
MTU: 1500
Translational Bridged VLAN: 1002
Translational Bridged VLAN: 1003
VLAN ISL Id: 2
Name: VLAN0002
Media Type: Ethernet
VLAN 802.10 Id: 100002
State: Operational
MTU: 1500
VLAN ISL Id: 3
Name: Red_VLAN
Media Type: Ethernet
VLAN 802.10 Id: 100003
State: Operational
MTU: 1500
VLAN ISL Id: 1002
Name: fddi-default
Media Type: FDDI
VLAN 802.10 Id: 101002
State: Operational
MTU: 1500
Bridge Type: SRB
Translational Bridged VLAN: 1
Translational Bridged VLAN: 1003
VLAN ISL Id: 1003
Name: token-ring-default
Media Type: Token Ring
VLAN 802.10 Id: 101003
State: Operational
MTU: 1500
Bridge Type: SRB
Ring Number: 0
Bridge Number: 1
Parent VLAN: 1005
Maximum ARE Hop Count: 7
Command Purpose
Step 1
Router#vlan database
Enters VLAN configuration mode.
Step 2
Router(vlan)#vlan vlan _ id
Adds an Ethernet VLAN.
Step 3
Router(vlan)#exit
Updates the VLAN database, propagates it throughout the
administrative domain, and returns to privileged EXEC mode.