Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
Configuring Cisco G.SHDSL HWICs
9
Examples
The following example use the G.SHDSL commands to configure an M-Pair group on a
HWIC-4SHDSL.
Router(config)#
Router(config)# controller shdsl 0/2/0
Router(config-controller)# dsl-group 1 pairs 0-1 m-pair
Router(config-controller-dsl-group)#
Sep 27 14:16:00.167: %HWIC_SHDSL-5-DSLGROUP_UPDOWN: SHDSL 0/2/0 dsl-group(1) state changed
to down.
Sep 27 14:16:02.167: %LINK-3-UPDOWN: Interface ATM0/2/1, changed state to down
Sep 27 14:16:03.167: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/2/1, changed
state to down
Router(config-controller-dsl-group)# shdsl annex a-b
Router(config-controller-dsl-group)# shdsl rate 2048
Router(config-controller-dsl-group)# exit
Router(config-controller)# exit
Router(config)#
Configuring 1-Pair Groups and 2-Pair Groups
To configure a 1-Pair group or 2-Pair group on a Cisco HWIC-4SHDSL or HWIC-2SHDSL, use the
Cisco IOS CLI on the router in global configuration mode.
SUMMARY STEPS
1. controller shdsl
2. dsl-group
3. shdsl 4-wire mode
(For 2-Pair groups only)
4. shdsl annex
5. shdsl rate
6. exit
7. exit
DETAILED STEPS
Command Purpose
Step 1
controller shdsl slot number/subslot number/0
Example:
Router (config)# controller shdsl 0/2/0
Router (config-controller)#
Selects the controller and enters config-controller
mode.
See the “controller shdsl” section on page 23 for
more information.
Step 2
dsl-group number pairs link number
Example(1-pair group):
Router (config-controller)# dsl-group 0 pairs 0
Example(2-pair group):
Router (config-controller)# dsl-group 0 pairs 0-1
Creates a DSL group and enters
config-controller-dsl-group mode.
See the “dsl-group” section on page 25 for more
information.