Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
Configuring Cisco G.SHDSL HWICs
8
Configuring M-Pair Groups
Use the Cisco IOS CLI on the router in global configuration mode to configure an M-Pair group on the
Cisco HWIC-4SHDSL.
Note To ensure a successful M-Pair group configuration, confirm that the central office (CO) network
equipment that is connected with the Cisco HWIC-4SHDSL supports M-Pair bonding.
SUMMARY STEPS
1. controller shdsl
2. dsl-group
3. shdsl annex
4. shdsl rate
5. exit
6. exit
DETAILED STEPS
Command Purpose
Step 1
controller shdsl slot number/subslot number/0
Example:
Router (config)# controller shdsl 0/2/0
Router (config-controller)#
Selects the controller and enters config-controller
mode.
See the “controller shdsl” section on page 23 for
more information.
Step 2
dsl-group number pairs link number [ima | m-pair]
Example:
Router (config-controller)# dsl-group 0 pairs 0-1
m-pair
Creates a DSL group and enters
config-controller-dsl-group mode.
See the “dsl-group” section on page 25 for more
information.
Step 3
shdsl annex {standard}
Example:
Router (config-controller-dsl-group)# shdsl annex A-B
Defines the SHDSL annex.
See the “shdsl annex” section on page 36 for more
information.
Step 4
shdsl rate { number | auto}
Example:
Router (config-controller)# shdsl rate 2048
Defines the SHDSL rate.
See the “shdsl rate” section on page 38 for more
information.
Step 5
exit
Example:
Router (config-controller-dsl-group)# exit
Exits config-controller-dsl-group mode.
Step 6
exit
Example:
Router (config-controller)# exit
Exits config-controller mode.