Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
Configuring Cisco G.SHDSL HWICs
7
Examples
The following example use the G.SHDSL commands to configure an IMA group on a HWIC- 4SHDSL.
Router(config)# controller shdsl 0/2/0
Router(config-controller)# dsl-group 1 pairs 1 ima
Router(config-controller-dsl-group)#?
dsl-group configuration sub commands:
default Set a command to its defaults
exit Exit dsl-group sub commands
ima IMA sub commands
no Negate a command or set its defaults
shdsl Symmetric g.shdsl configuration
shutdown Shutdown this dsl-group
Router(config-controller-dsl-group)# ima link add 2
Router(config-controller-dsl-group)# ima group minimum-links 2
Router(config-controller-dsl-group)# ima group clock-mode ?
ctc Common Transmit Clock configuration
itc Independent Transmit Clock configuration
Router(config-controller-dsl-group)# ima group clock-mode ctc ?
Router(config-controller-dsl-group)# shdsl annex a
Router(config-controller-dsl-group)# shdsl rate auto
Router(config-controller-dsl-group)# exit
Router(config-controller)# exit
Step 5
ima group clock-mode {ctc | itc}
Example:
Router (config-controller-dsl-group)# ima group
clock-mode ctc
Defines the clock mode for an IMA group.
See the “ima group clock-mode” section on
page 31 for more information.
Step 6
shdsl annex {standard}
Example:
Router (config-controller-dsl-group)# shdsl annex A
Defines the SHDSL annex.
See the “shdsl annex” section on page 36 for more
information.
Step 7
shdsl rate { number | auto}
Example:
Router (config-controller-dsl-group)# shdsl rate auto
Defines the SHDSL rate.
See the “shdsl rate” section on page 38 for more
information.
Step 8
exit
Example:
Router (config-controller-dsl-group)# exit
Exits config-controller-dsl-group mode.
Step 9
exit
Example:
Router (config-controller)# exit
Exits config-controller mode.
Command Purpose