Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
Configuring Cisco G.SHDSL HWICs
6
Configuring Cisco G.SHDSL HWICs
Configure DSL groups on the Cisco G.SHDSL HWIC, using the Cisco IOS CLI on the router in
privileged configuration mode.
• Configuring IMA Groups, page 6
• Configuring M-Pair Groups, page 8
• Configuring 1-Pair Groups and 2-Pair Groups, page 9
Configuring IMA Groups
Use the Cisco IOS CLI on the router in global configuration mode to configure an IMA group on the
Cisco HWIC-4SHDSL.
SUMMARY STEPS
1. controller shdsl
2. dsl-group
3. ima link add
4. ima group minimum-links
5. ima group clock-mode
6. shdsl annex
7. shdsl rate
8. exit
9. exit
DETAILED STEPS
Command Purpose
Step 1
controller shdsl slot number/subslot number/0
Example:
Router (config)# controller shdsl 0/2/0
Router (config-controller)#
Selects the controller and enters config-controller
mode.
See the “controller shdsl” section on page 23 for
more information.
Step 2
dsl-group number pairs link number [ima | m-pair]
Example:
Router (config-controller)# dsl-group 0 pairs 0-3 ima
Creates a DSL group and enters
config-controller-dsl-group mode.
See the “dsl-group” section on page 25 for more
information.
Step 3
ima link {add | delete | shutdown} number
Example:
Router (config-controller-dsl-group)# ima link add 2
Modifies links in an IMA group.
See the “ima link” section on page 33 for more
information.
Step 4
ima group {shutdown|minimum-links number | clock-mode}
Example:
Router (config-controller-dsl-group)# ima group
minimum-links 2
Modifies IMA group behavior.
See the “ima-group” section on page 28 for more
information.