Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
shdsl rate
39
Usage Guidelines Use the dsl-group command to create a DSL group, and then use the shdsl annex command to define
the G.991.2 standard for the newly created DSL group. Define the SHDSL line rate with the shdsl rate
command.
Examples The following example defines the SHDSL line rate for DSL group 1, pairs 0-1 (2 pairs) on a
Cisco HWIC-4SHDSL:
Router(config-controller)# dsl-group 1 pairs 0-1 ima
Router(config-controller-dsl-group)#
Sep 22 14:53:46.481: %HWIC_SHDSL-5-DSLGROUP_UPDOWN: SHDSL 0/2/0 dsl-group(1) state changed
to down.
Sep 22 14:53:48.481: %LINK-3-UPDOWN: Interface ATM0/2/IMA1, changed state to down
Sep 22 14:53:49.481: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/2/IMA1, changed
state to down
Router(config-controller-dsl-group)# shdsl annex ?
A Annex A of G.991.2 standard
A-B Annex A/B of G.991.2 standard
B Annex B of G.991.2 standard
Router(config-controller-dsl-group)# shdsl annex b ?
<cr>
Router(config-controller-dsl-group)# shdsl rate auto
<384-4608> DSL Rate in kbps(line will train at the rate + 16kbps overhead)
auto auto rate mode
Related Commands Command Description
dsl-group Creates a DSL group and enters config controller DSL group mode.
shdsl annex Defines the G.991.2 standard for a DSL group.