Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
shdsl annex
37
Usage Guidelines Use the dsl-group command to create a DSL group, and then use the shdsl annex command to define
the G.991.2 standard for the DSL group.
Examples The following example uses the shdsl annex command to define the annex standard for a 2-Pair DSL
group on a Cisco HWIC-4SHDSL:
Router(config-controller-dsl-group)# shdsl annex ?
A Annex A of G.991.2 standard
A-B Annex A/B of G.991.2 standard
B Annex B of G.991.2 standard
F Annex F of G.991.2 standard
F-G Annex F/G of G.991.2 standard
G Annex G of G.991.2 standard
Router(config-controller-dsl-group)# shdsl annex g ?
coding 16-TCPAM or 32-TCPAM line coding
Router(config-controller-dsl-group)# shdsl annex g coding ?
16-TCPAM 16-TCPAM line coding
32-TCPAM 32-TCPAM line coding
Router(config-controller-dsl-group)# shdsl annex g coding 16 ?
<cr>
Related Commands Command Description
dsl-group Creates a DSL group and enters config controller DSL group mode.
shdsl rate Defines the SHDSL rate.