Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
ima link
33
ima link
To modify an inverse multiplexing over ATM (IMA) group link, use the ima link command in config
controller DSL group mode.
ima link {add | delete | shutdown} number
Syntax Description
Command Defaults The default value is a minimum of 1 link.
Command Modes Config controller DSL group
Command History
Usage Guidelines Use the dsl-group command with the optional keyword, ima, to create an IMA DSL group. Then, use
the ima link command to define the links in the IMA group.
Examples The following example uses the ima link command to modify an IMA DSL group on a
Cisco HWIC-4SHDSL that is installed on a Cisco access router:
Router(config-controller-dsl-group)# ima link ?
add Add a link to the IMA group
delete Delete a link from the IMA group
shutdown Shutdown a link in the IMA group
Router(config-controller-dsl-group)# ima link add ?
<0-3> Link pair number
Router(config-controller-dsl-group)# ima link add 2 ?
<cr>
add Adds a link to an IMA group.
delete Deletes a link from an IMA group. The last link cannot be deleted from
an IMA group.
shutdown Shuts down a link in an IMA group.
number Defines the IMA link number.
Release Modification
12.4(15)T This command was introduced for the Cisco HWIC-4SHDSLrunning on
the Cisco 1841 router and on the Cisco 2800 and 3800 series
access routers.