Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
ima-group
28
ima-group
To define inverse multiplexing over ATM (IMA) groups, use the ima-group command in interface
configuration mode for Cisco 7100, 7200, and 7500 series routers; use the command in config controller
mode for the Cisco HWIC-4SHDSL. To remove the group, use the no form of this command.
Cisco HWIC-4SHDSL
ima-group [shutdown | minimum-links number | clock-mode]
Cisco 7100, 7200, and 7500 series routers
ima-group group-number
no ima-group group-number
Syntax Description
Command Defaults No IMA groups are defined.
Command Modes Cisco HWIC-4SHDSL
Config controller
Config controller DSL group
Cisco 7100, 7200, and 7500 series routers
Interface configuration
Command History
clock-mode Sets the clock mode for an IMA group
group-number Specifies an IMA group number from 0 to 3. IMA groups can span
multiple ports on a port adapter but cannot span port adapters.
minimum-links number Defines the number of minimum links that must remain in operation for
an IMA group to remain in service.
shutdown Shuts down physical links in an IMA group.
Release Modification
12.0(5)XK This command was introduced on Cisco 2600 and 3600 series routers.
12.0(5)T This command was integrated into Cisco IOS Release 12.0(5)T.
12.0(5)XE Support for Cisco 7200 and 7500 series routers was added.
12.0(7)XE1 Support for Cisco 7100 series routers was added.
12.1(5)T Support for Cisco 7100, 7200, and 7500 series routers was added
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.