Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers

dsl-group

Command Default No DSL group is defined.

Command Modes Config controller

Command History

Usage Guidelines From config-controller mode, use the dsl-group command to define the DSL group and enter

config-controller-dsl-group mode.

Examples The following example uses the dsl-group command to create an IMA-DSL group and enter

config-controller-dsl-group mode:

Router(config-controller)# dsl-group 1 pairs 0-1 ima

Router(config-controller-dsl-group)#

Sep 14 13:15:40.285:%HWIC_SHDSL-5-DSLGROUP_UPDOWN: SHDSL 0/2/0 dsl-group(1) state changed

to down.

Sep 14 13:15:42.285:%LINK-3-UPDOWN: Interface ATM0/2/IMA1, changed state to down

Sep 14 13:15:43.285:%LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/2/IMA1, changed

state to down

Related Commands

HWIC-2SHDSL

DSL Group 0

• 0

• 1

• 0-1

DSL Group 1

• 1

ima Defines a DSL group as an inverse multiplexing over ATM (IMA) group.

m-pair Defines a DSL group as an M-pair group.

Release Modification

12.4(15)T This command was introduced for the Cisco HWIC-4SHDSL and

HWIC-2SHDSL running on the Cisco 1841 router and the Cisco 2800 and

3800 series access routers.

Command Description

controller shdsl Configures a controller for SHDSL mode and enters

config-controller mode.

ima group Defines physical links as IMA group members.

ima group clock-mode Sets the clock mode for an IMA group.

ima link Defines physical links in an IMA group.