Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
dsl-group
25
dsl-group
To create a digital subscriber line (DSL) group and enter config-controller-dsl-group mode, use the
dsl-group command in config-controller mode. To disable the DSL group, use the no form of this
command.
dsl-group number pairs link number [ima| m-pair]
no dsl-group number pairs link number
Syntax Description number Defines the dsl-group number. The dsl-group number can be one of the following
numbers:
• 0
• 1
pairs Defines the DSL wire pairs.
link number Designates the pair’s link number. Link number options are limited to one of the
following choices, based on the hardware interface and the desired DSL group.
HWIC-4SHDSL
IMA DSL Group
• 0
• 1
• 2
• 3
• Any combination of the numbers 0,1,2,3
M-Pair DSL Group
• 0-1
• 0-2
• 0-3
2-Pair DSL Group
• 0-1
• 2-3
1-Pair DSL Group
• 0
• 1
• 2
• 3