Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
controller shdsl
24
Examples Cisco HWIC-4SHDSL and HWIC-2SHDSL
The following example uses the controller shdsl command to configure a Cisco HWIC-4SHDSL
installed in a Cisco access router, controller number 0, subslot 2, port number 0); the example enters
controller configuration mode:
Router(config)# controller shdsl 0/2/0
Router(config-controller)#
Cisco IAD2420 Series
The following example uses the controller shdsl command to enter SHDSL controller mode on
controller number 0; the example also configures ATM mode:
Router# controller shdsl 0
Router# mode atm
Related Commands Command Description
show controller shdsl Displays the controller status and statistics.