Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
Troubleshooting Cisco G.SHDSL HWICs
12
Troubleshooting Cisco G.SHDSL HWICs
To troubleshoot Cisco G.SHDSL HWICs, use the following new and published Cisco IOS commands.
All other Cisco IOS software commands used with G.SHDSL HWICs are documented in the Cisco IOS
Release 12.4(11) XJ command reference publication at Cisco.com:
http://www.cisco.com/en/US/products/ps6441/tsd_products_support_series_home.html
SUMMARY STEPS
1. show controllers shdsl
(new command)
2. show controllers atm
3. show ima interface
4. show ima interface atm
5. show atm pvc
DETAILED STEPS
Examples
The following example uses the show controllers shdsl command to display the controller status on a
HWIC-4SHDSL.
show controllers shdsl
Router# show controllers shdsl 0/2/0 detailed
Controller SHDSL 0/2/0 is UP
Command Purpose
Step 1
show controllers shdsl slot number/subslot number/0 [detailed |
brief]
Example:
Router# show controllers shdsl 0/2/0 detailed
Displays the status of SHDSL
controllers.
See the “show controllers shdsl”
section on page 40 for more
information.
Step 2
show controllers atm [ slot/subslot number /ima group-number ]
Example:
Router# show controllers atm 0/1/ima0
Displays information about the IMA
group.
Step 3
show ima interface
Example:
Router# show ima interface
Displays information about the IMA
interface.
Step 4
show ima interface atm [ slot/subslot number /ima group-number ]
[detailed]
Example:
Router# show ima interface atm 0/1/ima0
Displays detailed information about the
IMA interface.
Step 5
show atm pvc
Example:
Router# show atm pvc
Displays information about ATM
permanent virtual connections (PVCs)
and traffic information.