Installation guide

Configuring Cisco G.SHDSL HWICs in Cisco Access Routers
Configuring Cisco G.SHDSL HWICs
11
2-Pair Group Configuration
Router(config)# controller shdsl 0/2/0
Router(config-controller)# dsl-group 0 pairs 0-1
Router(config-controller-dsl-group)#
Oct 4 14:37:01.027: %HWIC_SHDSL-5-DSLGROUP_UPDOWN: SHDSL 0/2/0 dsl-group(0) state changed
to down.
Oct 4 14:37:03.027: %LINK-3-UPDOWN: Interface ATM0/2/0, changed state to down
Oct 4 14:37:04.027: %LINEPROTO-5-UPDOWN: Line protocol on Interface ATM0/2/0, changed
state to down
Router(config-controller-dsl-group)# shdsl ?
4-wire Symmetric g.shdsl 4-wire mode configuration
annex Symmetric g.shdsl Annex configuration
rate DSL line rate configuration
Router(config-controller-dsl-group)# shdsl 4-wire mode ?
enhanced 4-wire mode start up on both pairs
Router(config-controller-dsl-group)# shdsl 4-wire mode enhanced
Router(config-controller-dsl-group)# shdsl ?
4-wire Symmetric g.shdsl 4-wire mode configuration
annex Symmetric g.shdsl Annex configuration
rate DSL line rate configuration
Router(config-controller-dsl-group)# shdsl annex ?
A Annex A of G.991.2 standard
A-B Annex A/B of G.991.2 standard
B Annex B of G.991.2 standard
F Annex F of G.991.2 standard
F-G Annex F/G of G.991.2 standard
G Annex G of G.991.2 standard
Router(config-controller-dsl-group)# shdsl annex A-B
Router (config-controller-dsl-group)# shdsl rate ?
<384-4608> DSL Rate in kbps(line will train at the rate + 16kbps overhead)
auto auto rate mode
Router(config-controller-dsl-group)# shdsl rate 2048
Router(config-controller-dsl-group)# exit
Router(config-controller)# exit