Installation Guide

Chapter 1 Initial Installation of RNCS Software
38 78-4021167-01 Rev D
3 Click Add. The Hub Summary window is modified to allow you to configure a
new hub.
4 Configure the new hub with the following information:
Hub NameThe name you will use to identify this hub.
Hub IDThe number you will use to identify this hub.
HeadendThe headend associated with this hub.
Time ZoneThe time zone associated with this hub.
DST Zone IDThe DST Zone ID associated with this hub.
5 Click Save. The Hub Summary window updates.
6 If required, configure the new hub with a Hub Multicast Flow IP Address and a
Source IP Address.
7 Click Save.