Installation Guide

Logging on to the RNCS Servers
78-4021167-01 Rev D 5
13 Type setsc netsc_ipaddr [IP address] and press Enter. This command
establishes the unique IP address of the network management port.
Notes:
Substitute the IP address of the network management port of the RNCS
server for [IP address].
The network administrator can help you determine the IP address.
14 Type setsc netsc_ipnetmask [netmask] and press Enter. This command
establishes the netmask of the network management port.
Notes:
Substitute the netmask of the network management port of the RNCS server
for [netmask].
The network administrator can help you determine the netmask.
15 Type setsc netsc_ipgateway [IP address of gateway or router] and press Enter.
This command establishes the IP address of the gateway or router of the network
management port.
Notes:
Substitute the IP address of the gateway or router of the network
management port of the RNCS server for [IP address of gateway or router].
The network administrator can help you determine the IP address.
16 Type setsc sc_powerstatememory true and press Enter. This command sets the
sc_powerstatememory variable to true.
17 Type showsc and press Enter. The system displays the value of variables
associated with the ALOM port.
18 Is the sc_powerstatememory variable set to true?
If yes, type q to exit from the showsc display.
If no, type q to exit from the showsc display. Repeat this procedure from step
16.
19 Type resetsc and press Enter. A confirmation message appears.
20 Type y and press Enter. After a few messages, the system prompts you to type #.
to return to the ALOM port.
21 Type #. (Do not press Enter.). The Login prompt appears.
22 Did the Login prompt appear after you completed step 21?
If yes, go to step 23.
If no (the sc> prompt appeared), go to step 24.
23 If the Login prompt appeared after you completed step 21, follow these
instructions.
a Type admin and press Enter.
b Type the admin password and press Enter. The sc> prompt appears.