Datasheet

Data Sheet
© 1992-2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 4 of 8
Enhanced Predictive Failure Analysis
The Cisco MCS 7835-I2 supports Enhanced Predictive Failure Analysis (PFA) on hot-swap fans,
power supplies, processors, and memory and voltage regulator modules. Through diagnostics, the
Cisco MCS 7835-I2 anticipates failures in these devices and generates an alert, allowing service
personnel to quickly replace the components before a failure actually occurs. An example of PFA
is its ability to monitor variations in electrical input/output to the power supplies and cooling fans.
DAT Support
The Cisco MCS 7835-I2 appliance can support an optional 36-/72-GB USB external Digital Audio
Tape (DAT) drive (part number DAT-USB-EXT-72=) or an optional USB rack-mount DAT drive
(part number DAT-USB-RM-72=). This tape drive connects through one of the 4 USB 2.0 ports
provided by the Cisco MCS 7835-I2 appliance.
Product Specifications
Table 1 lists product specifications for the Cisco MCS 7835-I2 Unified Communications Manager
Appliance.
Table 1. Product Specifications
Processor at Product Introduction
Processor (CPU) Intel Woodcrest Xeon DP
Processor internal clock
speed
2.33 GHz
Level 2 cache 4096 KB
Maximum processors 2
Processors installed 1
Basic input/output system
(BIOS) type
Flash memory
Memory
Memory maximum 48 GB
Memory bus clock 667 MHz
Memory technology PC2-5300 667 MHz DDR2 SDRAM
Multibit error mitigation Advanced Error Checking and Correcting (AECC)
Total RAM slots 12
Memory installed 2 GB (two 1-GB dual in-line memory modules [DIMMs])
RAID Controller
Controller model IBM mezzanine ServeRAID-8k controller
Interface Connected to motherboard
Cache 256 MB
Battery-backed write caching Yes
RAID levels supported 1
Hard Disk
Hard disk installed Two 72.3-GB SAS drives
Hard-disk route processor
module (RPM)
10,000
Hard-disk average seek time 4 ms
Hot-swappable bays 8
Hard-disk interface type SAS
Data-transfer rate 300 MB per second