System information

Polycom® Unified Communications Deployment Guide for Cisco Environments

• Task 3: Verify Subzones and Bandwidth Limits

Task 1: Adding a Neighbor Zone

VCS uses the concept of “zones” to configure neighbors.

To add a H323 neighbor zone:

1 From the VCS web administration pages, select VCS Configuration > Zones.

2 Click New to create a new neighbor.

3 Configure a Name that is meaningful for your deployment, and select Neighbor from the

Type dropdown list. The Neighbor Zone configuration parameters are then displayed.

4 Many settings can be left at default, but note the following parameters.

a Under H.323, select a Mode of On from the dropdown list.

b Under SIP, select a Mode of Off from the dropdown list.

c Under Location, configure the Peer 1 address with the Virtual IP Address of your DMA

node. Alternatively, you can configure the Fully Qualified Domain Name (FQDN) of the

DMA SuperCluster.

d Under Advanced, the Default Zone profile will work for most deployments; however, the

VCS administrator should be consulted for any custom H323 attributes that are specific

to your deployment.