System information

Polycom RealPresence Platform SIP Integration with CUCM
51
c Fill in all other pertinent information for your network, such as Route Partition or
Calling Party Transformations if any digit manipulation is required.
d In the Call Classification field, select OnNet.
Provide Outside Dial Tone is typically NOT checked.
4 Once complete, click Save.
Note: Using Route Groups and Route Lists
If a route pattern is pointed directly at a trunk, any subsequent route patterns that
are added will reset and drop ALL calls on the trunk. The use of route groups and
route lists allows calls to stay active while adding route patterns.
Once you complete the above steps, proceed to the next section.
Configuring DMA for SIP Integration with CUCM
On the DMA system, you need to configure an external SIP peer for CUCM. This allows the
DMA system to route and receive SIP calls to devices registered to CUCM.
Perform the following tasks:
• Task 1: Configuring a SIP Peer
• Task 2: Setting up a Dial Rule
• Task 3: Creating a TIP-Enabled Conference Template (Optional)