System information

Polycom® Unified Communications Deployment Guide for Cisco Environments
50
The following is shown for example where the destination DMA system has the Virtual
IP Address “10.10.10.10”.
9 Click Save.
10 Click Apply Config to apply your changes.
Task 3: Adding a Route Pattern
In this task, you create a route pattern which defines a specific dial pattern or patterns that
should be sent to the DMA SIP trunk created in Task 2. Video calls are an automatic negotiation
as part of the call setup.
Note: Using the Route Groups and Route Lists
If your CUCM implementation uses the Route Group, Route List construct, it is also
possible to add the DMA SIP trunk to that construct. Associating the SIP trunk directly to
a Route Pattern is shown here for simplicity.
To add a route pattern:
1 Navigate to Call Routing > Route/Hunt > Route Pattern.
2 Click Add New.
3 Add a route pattern representing a single E.164 conference extension or range of
extensions available on the DMA system.
a In the Route Pattern field, enter a name for the pattern. This example uses 6071XXXX.
b From the Gateway/Route List dropdown, select the SIP Trunk you created in Task 2.