Installation guide

Configuration Tasks
8
Cisco IOS 11.2(15)GS2
You must have a version of Cisco IOS software installed that supports the GRP redundant processor
feature in a Cisco 12000 series router. Table 1 lists the minimum Cisco IOS software releases and
image names for GRP redundant processor support.
Configuration Tasks Overview
Specific tasks for GRP redundant processor configuration on a Cisco 12000 series router are
described in the following sections:
• Installing Second GRP and Configuring Hardware Backup Task List
• Configuring Software Error Protection Task List
• Managing The Primary and Secondary GRP Task List
• Monitor and Maintain GRP Redundant Processor Operation Task List
Note Configure redundant operation with a single GRP installed in the router, before installing the
second GRP. This sequence prevents conflicts with older software versions that do not support GRP
redundancy.
Installing Second GRP and Configuring Hardware Backup Task List
When installing a second GRP in a Cisco 12000 series router, complete the tasks in the following
sections. All tasks in the following list are required for configuring simple hardware backup.
• Verify Cisco IOS Software Version on the Installed GRP
• Verify Cisco IOS Software Installed in Bootflash
• Install Firmware Upgrades
• Configure Redundancy on the Installed GRP
• Prepare the Flash Device for the New GRP
• Install the New GRP and Boot to ROM Monitor Prompt
• Boot the Primary and Secondary GRPs in Sequence
• Verify Redundant Operation
• Verify and Update Cisco IOS Software on Secondary GRP
Table 1 Cisco 12000 Series Router Software with GRP Redundant Processor Support
Cisco IOS Software Release Image Name
Cisco IOS Release 11.2(15)GS2 or
later version of 11.2 GS.
gsr-p-mz.112-15GS2
Cisco IOS Relase 12.0(5)S or later
version of 12.0 S.
Available in 1999