Installation guide

Command Reference
22
Cisco IOS 11.2(15)GS2
hw-module config-register
Use the hw-module config-register global configuration command to define different system
configuration register parameters for the primary GRP and the secondary GRP. Use the no version
of the command to restore default configuration register parameters.
hw-module slot number config-register hex-number
no hw-module slot number config-register
Syntax Description
Default
When no parameters are modified by using this command, the values configured via the
config-register global configuration command.
Command Mode
Global configuration
Usage Guidelines
This command first appeared in Cisco IOS Release 11.2 GS.
Use this command to set the configuration registers to different values on the primary or secondary
GRP. You need not use this command when you want the same values on both the primary and
secondary GRP.
Example
The following example sets the configuration register for the GRP installed in chassis slot 3:
hw-module slot 3 config-register 0x02
Related Commands
hw-module boot system
number Slot number where the GRP is installed.
hex-number Register number value between 0x0 and 0xFF.