System information

Cha
p
te
r
5 ICIM Mode Commands
150 4025561 Rev
A
user add
Syntax
user add username authlevel accountstatus
Description
The user add command is used to add a new login and password to the ICIM2
authentication table. A dialog is used to obtain and validate the password.
Parameters
The username, or user identifier, must be 6 to 14 characters in length and contain
both letters and numbers. The username cannot include special characters. An
example of a valid username is abc123.
The authlevel, or authorization level, may be one of the following:
authlevel Description
Admin Equivalent to a Unix superuser (root) and should be allowed for
only the most trusted logins. An Admin can change passwords, IP
addresses, and other critical values.
Readwrite Allows typical operations, including the ability to change control
values and alarm parameters.
Read Allows the user to read non-critical values only, and has no write
permissions.
The accountstatus may be one of the following:
accountstatus Description
Enable The account is enabled.
Disable The account is created but disabled.
Note: After entering this command, you will be prompted to enter a password for
the user. The password must be 6 to 14 characters in length and contain both letters
and numbers. Unlike the username, the password may contain special characters.
Access Rights Required
Admin