Specifications

4-23
PA-T3+ Serial Port Adapter Installation and Configuration
OL-3505-03
Chapter 4 Configuring the PA-T3+
Checking the Configuration
Using the show interfaces Command
The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify. The following examples show output for some of the supported
platforms; all of the examples specify serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for
Cisco 7200 series or Cisco 7401ASR router, and VIP interfaces, refer to the publications listed in the
“Related Documentation” section on page viii.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Catalyst 6000 Family FlexWAN Module in Catalyst 6000 Family Switches
Following is an example of the show interfaces command used with the FlexWAN module. In this
example, the two serial interfaces (0 to 1) are on a port adapter in bay 0 of a FlexWAN module in
module slot 9; also, most of the status information for each interface is omitted. (Interfaces are
administratively shut down until you enable them.)
router# show interfaces serial 9/0/0
Serial9/0/0 is administratively down, line protocol is down
Hardware is PODS3+ Serial
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
[Additional display text omitted from this example]
router# show interfaces serial 9/0/1
Serial9/0/1 is administratively down, line protocol is down
Hardware is PODS3+ Serial
MTU 4470 bytes, BW 44210 Kbit, DLY 200 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
[Additional display text omitted from this example]
Cisco 7200 Series Routers
Following is an example of the show interfaces command for Cisco 7200 series routers. In this example,
the serial two interfaces (0 to 1) are on a port adapter in port adapter slot 1; also, most of the status
information for each interface is omitted. (Interfaces are administratively shut down until you enable
them.)
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is M8T-RS232
Internet address is 10.0.0.0
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text omitted from this example]
Router# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Hardware is M8T-RS232
Internet address is 10.0.0.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive set (10 sec)
[Additional display text omitted from this example]