Specifications

4-18

PA-T3+ Serial Port Adapter Installation and Configuration

OL-3505-03

Chapter 4 Configuring the PA-T3+

Checking the Configuration

If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is

not functioning properly, ensure that the interface is properly connected and terminated. If you still have

problems bringing up the interface, contact a service representative for assistance. This section includes

the following subsections and offers platform-specific output examples for some of the supported

platforms:

• Using the show version or show hardware Commands, page 4-18

• Using the show diag Command, page 4-21

• Using the show interfaces Command, page 4-23

Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify

Network Connectivity” section on page 4-24 when you have finished using the show commands.

Using the show version or show hardware Commands

Display the configuration of the system hardware, the number of each interface type installed, the Cisco

IOS software version, the names and sources of configuration files, and the boot images, using the show

version (or show hardware) command.

Note The outputs that appear in this document may not match the output you receive when running these

commands. The outputs in this document are examples only and not all platforms are represented.

Catalyst 6000 Family FlexWAN Module in Catalyst 6000 Family Switches

Following is an example of the show version command from a Catalyst 6000 family switch with the

PA-T3+:

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) MSFC Software (C6MSFC-JSV-M), Experimental Version 12.1(20000209:134547)

[amcrae-cosmos_e_nightly 163]

Compiled Wed 09-Feb-00 07:10 by

Image text-base: 0x60008900, data-base: 0x6140E000

ROM: System Bootstrap, Version 12.0(3)XE, RELEASE SOFTWARE

const-uut uptime is 5 minutes

System returned to ROM by reload

System image file is "bootflash:c6msfc-jsv-mz.Feb9"

cisco Cat6k-MSFC (R5000) processor with 122880K/8192K bytes of memory.

show protocols Displays protocols configured

for the entire system and for

specific interfaces

Router# show protocols

show running-config Displays the running

configuration file

Router# show running-config

show startup-config Displays the configuration

stored in NVRAM

Router# show startup-config

Table 4-8 Using show Commands (continued)

Command Function Example