Specifications

CHAPTER
2-1
PA-T3+ Serial Port Adapter Installation and Configuration
OL-3505-03
2
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
PA-T3+ port adapter. This chapter contains the following sections:
• Required Tools and Equipment, page 2-1
• Software and Hardware Requirements, page 2-2
• 75-Ohm In-Line Coaxial Attenuator, page 2-3
• Checking Hardware and Software Compatibility, page 2-3
• Safety Guidelines, page 2-3
Required Tools and Equipment
You need the following tools and parts to install a port adapter. If you need additional equipment, contact
a service representative for ordering information.
• PA-T3+ serial port adapter.
• Catalyst 6000 family FlexWAN module.
• VIP (for installation in Cisco 7000 series or Cisco 7500 series chassis only). For information about
the specific VIP models that support the PA-T3+, see the “Software and Hardware Requirements”
section on page 2-2.
• Cisco 7304 PCI Port Adapter Carrier Card (for installation in a Cisco 7304 router).
• 75-ohm coaxial serial interface cables.
• Number 1 Phillips and a 3/16-inch, flat-blade screwdriver (for VIP installation only).
• Number 2 Phillips screwdriver.
• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.
• Antistatic mat.
• Antistatic container.
• Attenuator kit (optional).