Specifications

1-5
PA-T3+ Serial Port Adapter Installation and Configuration
OL-3505-03
Chapter 1 Overview
Management Information Base
You can test the DTE-to-DCE cable connection by using the loopback dte command. See the “Using
loopback Commands” section on page 4-25, for more information.
Management Information Base
Management Information Base (MIB) attributes are readable and writable across ILMI through use of
the SNMP.
The one-port PA-T3+ supports all MIB-II (RFC 1213) and the DS3 interface MIB (RFC 1407).
The two-port PA-2T3+ supports MIB-II (RFC 1213) and the DS3 interface MIB (RFC 1407).
Port Adapter Slot Locations on the Supported Platforms
This section discusses port adapter slot locations on the supported platforms. The illustrations that
follow summarize slot location conventions on each platform:
• Catalyst 6000 Family FlexWAN Module Slot Numbering, page 1-5
• Cisco 7200 Series Routers Slot Numbering, page 1-6
• Cisco 7301 Router Slot Numbering, page 1-7
• Cisco 7304 PCI Port Adapter Carrier Card Slot Numbering, page 1-7
• Cisco 7401ASR Router Slot Numbering, page 1-8
• VIP Slot Numbering, page 1-9
Catalyst 6000 Family FlexWAN Module Slot Numbering
The Catalyst 6000 family FlexWAN module can be installed in any slot except slot 1, which is reserved
for the supervisor engine. The PA-T3+ can be installed into either port adapter bay 0 or bay 1 on a
FlexWAN module. Figure 1-6 shows a FlexWAN module with two blank port adapters installed.
Note Slot 1 is reserved for the supervisor engine. If a redundant supervisor engine is used, it would go in slot
2; otherwise, slot 2 can be used for other modules.