Specifications

5-26
PA-8T-V.35 Synchronous Serial Port Adapter Installation and Configuration
OL-3563-03
Chapter 5 Configuring the PA-8T-V.35 Interfaces
Checking the Configuration
For complete descriptions of interface subcommands and the configuration options available for Catalyst
RSM/VIP2, Catalyst 6000 family FlexWAN module, Cisco 7100 series, Cisco 7200, Cisco uBR7200
series, Cisco 7301 routers, Cisco 7401ASR router, and VIP interfaces, refer to the publications listed in
the “Related Documentation” section on page viii.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches
In these examples, the serial interfaces are in port adapter slot 1; also, most of the status information for
each interface is omitted. (Interfaces are administratively shut down until you enable them.)
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is cxBus Serial
Internet address is 10.0.0.0
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
(display text omitted)
Router# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Hardware is cxBus Serial
Internet address is 10.0.0.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
(display text omitted)
Catalyst 6000 Family FlexWAN Module
In these examples, the serial interfaces are on a port adapter in port adapter bay 1 of a Catalyst 6000
family FlexWAN module in module slot 8; also, most of the status information for each interface is
omitted. (Interfaces are administratively shut down until you enable them.)
Router# show interfaces serial 8/1/0
Serial8/1/0 is administratively down, line protocol is down
Hardware is Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
(display text omitted)
Router# show interfaces serial 8/1/1
Serial8/1/1 is administratively down, line protocol is down
Hardware is Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
(display text omitted)
Router# show interfaces serial 8/1/2
Serial8/1/2 is administratively down, line protocol is down
Hardware is Serial
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, crc 16, loopback not set
(display text omitted)