Specifications

5-19
PA-8T-V.35 Synchronous Serial Port Adapter Installation and Configuration
OL-3563-03
Chapter 5 Configuring the PA-8T-V.35 Interfaces
Checking the Configuration
If an interface is shut down and you configured it as up, or if the displays indicate that the hardware is
not functioning properly, ensure that the interface is properly connected and terminated. If you still have
problems bringing up the interface, contact a service representative for assistance. This section includes
the following subsections:
• Using the show version or show hardware Commands, page 5-19
• Using the show diag Commands, page 5-23
• Using the show interfaces Commands, page 5-25
Choose the subsection appropriate for your system. Proceed to the “Using the ping Command to Verify
Network Connectivity” section on page 5-29 when you have finished using the show commands.
Using the show version or show hardware Commands
Display the configuration of the system hardware, the number of each interface type installed, the
Cisco IOS software version, the names and sources of configuration files, and the boot images, using
the show version (or show hardware) command. This section provides output examples for some of the
supported platforms.
Note The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches
Following is an example of the show version command from a Catalyst 5000 family switch with the
PA-8T-V.35:
Router# show version
Cisco Internetwork Operating System Software
IOS (tm) C5RSM Software (C5RSM-JSV-M), Version 11.2(9)P
show interfaces type 1/
interface-port-number
Displays status information
about a specific type of interface
(for example, ethernet) in a
Cisco 7401ASR router
Router# show interfaces serial 1/0
show interfaces type interface-processor-
slot-number/port-adapter-slot-number/
interface-port-number
Displays status information
about a specific type of interface
(for example, serial) on a VIP in
a Cisco 7000 series or
Cisco 7500 series router
Router# show interfaces serial 3/1/0
show protocols Displays protocols configured
for the entire system and for
specific interfaces
Router# show protocols
show running-config Displays the running
configuration file
Router# show running-config
show startup-config Displays the configuration
stored in NVRAM
Router# show startup-config
Table 5-8 Using show Commands (continued)
Command Function Example