Specifications

5-8
PA-8T-V.35 Synchronous Serial Port Adapter Installation and Configuration
OL-3563-03
Chapter 5 Configuring the PA-8T-V.35 Interfaces
Configuring the Interface
Performing a Basic Configuration
Following are instructions for a basic configuration: enabling an interface, specifying IP routing, and
setting up external timing on a DCE interface. You might also need to enter other configuration
subcommands, depending on the requirements for your system configuration and the protocols you plan
to route on the interface. For complete descriptions of configuration subcommands and the configuration
options available for serial interfaces, refer to the appropriate software documentation.
In the following procedure, press the Return key after each step unless otherwise noted. At any time you
can exit the privileged level and return to the user level by entering disable at the prompt as follows:
Router# disable
Router>
Step 1 At the privileged-level prompt, enter configuration mode and specify that the console terminal is the
source of the configuration subcommands as follows:
Router# configure terminal
Enter configuration commands, one per line. End with Crtl-Z.
Router(config)#
Step 2 Specify the first interface to configure by entering the interface serial subcommand, followed by the
interface address of the interface you plan to configure. Table 5-3 provides examples.
Table 5-3 Examples of the interface serial Subcommand
Platform Command Example
Catalyst RSM/VIP2 in Catalyst 5000
family switches
interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
The example is for interface 0 of a
port adapter in port adapter slot 0.
Router(config)# interface serial 0/0
Router(config-if)#
Catalyst 6000 family FlexWAN module
in Catalyst 6000 family switches
interface serial, followed by
mod_num/bay/port
(module-slot-number/
port-adapter-bay-number/
interface-port-number)
The example is for interface 0 of a
port adapter in port adapter bay 0 of a
FlexWAN module in module slot 3.
Router(config)# interface serial 3/0/0
Router(config-if)#
Cisco 7120 series routers interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
The example is for interface 0 of a
port adapter in port adapter slot 3.
Router(config)# interface serial 3/0
Router(config-if)#
Cisco 7140 series routers interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
The example is for interface 0 of a
port adapter in port adapter slot 4.
Router(config)# interface serial 4/0
Router(config-if)#
Cisco 7200 series routers interface serial, followed by
slot/port
(port-adapter-slot-number/
interface-port-number)
The example is for interface 0 of a
port adapter in port adapter slot 6.
Router(config)# interface serial 6/0
Router(config-if)#