Specifications

CHAPTER
2-1
PA-8T-V.35 Synchronous Serial Port Adapter Installation and Configuration
OL-3563-03
2
Preparing for Installation
This chapter describes the general equipment, safety, and site preparation requirements for installing the
Cisco PA-8T-V.35 port adapter. This chapter contains the following sections:
• Required Tools and Equipment, page 2-1
• Software and Hardware Requirements, page 2-2
• Checking Hardware and Software Compatibility, page 2-3
• Safety Guidelines, page 2-3
• FCC Class A Compliance, page 2-9
Required Tools and Equipment
You need the following tools and parts to install a port adapter. If you need additional equipment, contact
a service representative for ordering information.
• PA-8T-V.35(=) port adapter.
• Catalyst RSM/VIP2 (for installation in the Catalyst 5000 family switches). For information about
the specific VIP2 models that support the PA-8T-V.35, see the “Software and Hardware
Requirements” section on page 2-2.
• Catalyst 6000 family FlexWAN module (for installation in the Catalyst 6000 family switches).
• VIP (for installation in Cisco 7000 series or Cisco 7500 series chassis only). For information about
the specific VIP models that support the PA-8T-V.35, see the “Software and Hardware
Requirements” section on page 2-2.
• Cisco 7304 PCI Port Adapter Carrier Card (for installation in a Cisco 7304 router).
• PA-8T-V.35 compact serial cable (PA-8T-V.35 compact serial cables are available only from
Cisco Systems; they are not available from outside commercial cable vendors).
• Number 1 Phillips and a 3/16-inch flat-blade screwdriver (for VIP installation only).
• Number 2 Phillips screwdriver.
• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, field-replaceable units (FRUs), and spares.
• Antistatic mat.
• Antistatic container.