Specifications

1-22
PA-8T-V.35 Synchronous Serial Port Adapter Installation and Configuration
OL-3563-03
Chapter 1 Overview
Identifying Interface Addresses
Catalyst RSM/VIP2 Interface Addresses
This section describes how to identify the interface addresses used for the PA-8T-V.35 on the
Catalyst RSM/VIP2 in the Catalyst 5000 family switches. The interface address is composed of a
two-part number in the format port-adapter-slot number/interface-port number.
See Table 1-5 for the interface address format.
Catalyst 6000 Family FlexWAN Module Interface Addresses
This section describes how to identify the interface addresses used for the PA-8T-V.35 on the
Catalyst FlexWAN module in the Catalyst 6000 family switches.The interface address is composed of a
three-part number in the format module-number/port-adapter-bay-number/interface-port-number.
See Table 1-5 on page 1-21 for the interface address format.
Cisco 7140 series routers Port-adapter-slot-number/interface-port-number Port adapter slot—always 4
Interface port—0 through 7
4/0
Cisco 7200 series routers Port-adapter-slot-number/interface-port-number Port adapter slot—0 through 6
(depends on the number of slots
in the router)
2
Interface port—0 through 7
1/0
Cisco uBR7223 router Port-adapter-slot-number/interface-port-number Port adapter slot—always 1
2
Interface port—0 through 7
1/0
Cisco uBR7246 and
Cisco uBR7246VXR
routers
Port-adapter-slot-number/interface-port-number Port adapter slot—always 1 or 2
2
Interface port—0 through 7
1/2
Cisco 7301 routers Port-adapter-slot-number/interface-port-number Port adapter slot—always 1
Interface port—0 through 7
1/0
Cisco 7304 PCI Port
Adapter Carrier Card in
Cisco 7304 routers
Port-adapter-slot-number/interface-port-number Port adapter slot—router module
slot 2 through 5
Interface port—0 through 7
3/0
Cisco 7401ASR routers Port-adapter-slot-number/interface-port-number Port adapter slot—always 1
Interface port—0 through 7
1/0
VIP in Cisco 7000 series
or Cisco 7500 series
routers
Interface-processor-slot-number/port-adapter-
slot-number/interface-port-number
Interface processor slot—0
through 12 (depends on the
number of slots in the router)
Port adapter slot—always 0 or 1
Interface port—0 through 7
3/1/0
1. Slot 1 is reserved for the supervisor engine. If a redundant supervisor engine is used, it must go in slot 2; otherwise, slot 2 can be used for other modules.
2. Port adapter slot 0 is reserved for the Fast Ethernet port on the I/O controller (if present).
Table 1-5 Identifying Interface Addresses (continued)
Platform Interface Address Format Numbers Syntax