Specifications

4-21
Cisco PA-FE-TX and Cisco PA-FE-FX Fast Ethernet 100BaseT Port Adapter Installation and Configuration
OL-2899-02
Chapter 4 Configuring the PA-FE-TX or PA-FE-FX
Checking the Configuration
Cisco 7401ASR Routers—Example Output of the show interfaces Command
Using the show interfaces type slot-number/interface-port-number command displays status
information about a specific type of interface—in this example, ATM interfaces—on a Cisco 7401ASR
router.
Following is an example of the show interfaces command for a Cisco 7401ASR router. In this example,
the eight ATM interfaces (0 through 7) are on a module in slot 1.
Router# show interfaces atm 1/1
ATM1/1 is up, line protocol is down
Hardware is IMA PA
Internet address is 192.168.0.0/24
MTU 4470 bytes, BW 1536 Kbit, DLY 20000 usec,
reliablility 255/255, txload 1/255, rxload 1/255
Encapsulation UNKNOWN, loopback not set
Keepalive set (10 sec)
Encapsulation(s):AAL5
512 maximum active VCs, 0 current VCCs
VC idle disconnect time:300 seconds
2 carrier transitions
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Input queue:0/75/0 (size/max/drops); Total output drops:0
Queueing strategy:weighted fair
Output queue:0/1000/64/0 (size/max total/threshold/drops)
Conversations 0/0/256 (active/max active/max total)
Reserved Conversations 0/0 (allocated/max allocated)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Cisco 7500 Series Routers with VIP—Example Output of the show interfaces Command
Using the show interfaces type interface-processor-slot-number/module-slot-number/
interface-port-number command displays the status information about a specific type of interface
—in this example, serial interfaces—on a Cisco 7500 series router.
Following is an example of the show interfaces command used with a VIP2. In this example, the eight
serial interfaces (0 to 7) are on a module in slot 1 of a VIP2 in interface processor slot 3; also, most of
the status information for each interface is omitted. (Interfaces are administratively shut down until you
enable them.)
Router# show interfaces serial 3/1/0
Serial3/1/0 is up, line protocol is up
Hardware is cyBus Serial
Internet address is 10.0.0.0
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
[Additional display text omitted from this example]